Administrator Guide

Layer 3 Routing Commands 1584
Number of Active Areas ........................ None
show ipv6 route
Use the show ipv6 route command in User Exec or Privileged Exec mode to
display the IPv6 routing table. The output of the command also displays the
IPv6 address of the default gateway and the default route associated with the
gateway.
Syntax
show ipv6 route [ipv6-address | ipv6-prefix/prefix-length | protocol |
interface-type interface-number] [best]
• ipv6-address—Specifies an IPv6 address for which the best-matching
route would be displayed.
• protocol—Specifies the protocol that installed the routes. Is one of the
following keywords: connected, ospf, static.
• ipv6-prefix/ prefix-length—Specifies an IPv6 network for which the
matching route would be displayed.
• interface-type interface-number—Valid IPv6 interface. Specifies that the
routes with next-hops on the selected interface be displayed. Supported
interface types are VLAN, Tunnel, and Loopback.
• best—Specifies that only the best routes are displayed. If the connected
keyword is selected for protocol, the best option is not available because
there are no best or non-best connected routes.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.