Administrator Guide

Layer 3 Routing Commands 1619
Example
console#show ip pim bsr-router
BSR Address............................. 192.168.10.1
BSR Priority............................ 0
BSR Hash Mask Length.................... 30
C-BSR Advertisement Interval (secs)........60
Next Bootstrap message(hh:mm:ss).......... NA
If no configured/elected BSRs exist on the router, the following message is
displayed.
No BSR’s exist/learned on this router.
show ip pim interface
The show ip pim interface command displays the PIM interface status
parameters. If the interface number is not is specified, the command displays
the status parameters of all the PIM-enabled interfaces.
Syntax
show ip pim interface [vlan vlan-id]
• vlan-id — A valid VLAN ID for which multicast routing has been enabled.
Field Descriptions
Next Bootstrap Message
in
Time remaining (in hours, minutes, and seconds) until a
BSR message is sent.
Next Candidate RP
Advertisement
Time remaining (in hours, minutes, and seconds) until the
next RP advertisement is sent.
Field Description
Mode Active PIM Protocol
Interface Interface number
Hello Interval Hello interval value
Join-prune Interval Join-prune interval value
DR Priority DR Priority configured on this interface
BSR Border Whether or not this interface is configured as a BSR Border