Administrator Guide

Switch Management Commands 2032
Port Configuration
==================
Port Powered Device State Priority Status Class Power[mW]
--------- ---------------------- ----- -------- ----------- ------ ---------
Gi1/0/1 auto Low Searching Unknown
Gi1/0/2 auto Low Searching Unknown
Gi1/0/3 auto Low Searching Unknown
Gi1/0/4 auto Low Searching Unknown
Command History
Description revised in version 6.3.1.5 release.
Description revised in version 6.3.1.6 release. Example revised in 6.4 release.
power inline powered-device
The power inline powered-device command adds a comment or description
of the powered device type to enable the user to remember what is attached
to the interface. To remove the description, use the no form of this command.
Syntax
power inline powered-device pd-type
no power inline powered-device
• pd-type — Specifies the type of powered device attached to the
interface. (Range: 1–20 characters)
Command Mode
Interface Configuration (Ethernet).
User Guidelines
No specific guidelines.
Examples
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)# power inline powered-device IP-phone