Administrator Guide

Switch Management Commands 2093
VPC peer link data message tracing enabled.
debug vrrp
Use the debug vrrp command to enable VRRP debug protocol messages. Use
the no form of this command to disable VRRP debug protocol messages.
Syntax
debug vrrp all
no debug vrrp all
Default Configuration
The display of VRRP traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
exception core-file
Use the exception core-file command to configure the core dump file name.
Use the no form of the command the reset the core file name to the default.
Syntax
exception core-file file-name [hostname [time-stamp] | time-stamp
[hostname]]
no exception core-file
• file-name — The file name. The maximum length is 15 characters.
Embedded blanks may not be allowed by the host file system (for
example, TFTP server) and are not recommended.