Administrator Guide

Switch Management Commands 2231
Default Configuration
This command has no default configuration.
Command Modes
All modes
User Guidelines
The show interface command shows the actual operational status of the
interface, which is not necessarily the same as the configuration.
Input/output rate statistics are collected every 10 seconds.
The RX and TX utilization (sum of the individual active links) is shown for
port-channels. The utilization is measured in kilobits per second.
Command History
Updated examples and guidelines in version 6.5 firmware.
Example
The following example shows the output for a 1G interface:
console#show interfaces gi1/0/1
Interface Name : .............................. Gi1/0/1
SOC Hardware Info :............................ BCM56342_A0
Link Status : ................................. Up
Keepalive Enabled.............................. True
Err-disable Cause.............................. None
VLAN Membership Mode: ......................... Trunk Mode
VLAN Membership: .............................. (1),2-3,101-113,813,3232
MTU Size : .................................... 1518
Port Mode [Duplex] : .......................... Full
Port Speed : .................................. 1000
Link Debounce Flaps : ......................... 0
Auto-Negotation Status : ...................... Auto
Burned MAC Address : .......................... 001E.C9DE.B110
L3 MAC Address................................. 001E.C9DE.B112
Sample load interval : ........................ 300
Received Input Rate Bits/Sec : ................ 784
Received Input Rate Packets/Sec : ............. 1
Transmitted Input Rate Bits/Sec : ............. 1344
Transmitted Input Rate Packets/Sec : .......... 1