Administrator Guide

Switch Management Commands 2256
The additional fields in the all units example are as follows:
Preconfigured Model Identifier This field displays the model identifier for this
switch. Model Identifier is a 32-character field
assigned by Dell to identify the switch.
Plugged-in Model Identifier This field displays the model identifier for this
switch. Model Identifier is a 32-character field
assigned by Dell to identify the switch. If no
physical unit is present for the unit number, this
field is empty.
Switch Status This field displays the switch status. Possible
values are OK, Unsupported, Code Mismatch,
Config Mismatch, SDM Mismatch Not Present,
Updating Code, or STM Mismatch
Switch Description This field displays the switch description.
Detected Code Version This field displays the version of code running
on this switch. If the switch is not present and
the data is from preconfiguration, the code
version is “None.”
Detected Code in Flash This field displays the version of code that is
currently stored in FLASH memory on the
switch. This code will execute after the switch is
reset. If the switch is not present and the data is
from preconfiguration, then the code version is
“None.”
SFS Last Attempt Status This field displays the Stack Firmware
Synchronization status. The possible values are:
Success, Failure, Min bootcode version not
present, None.
Serial Number This field displays the Switch serial number.
Up Time This field displays the system up time.
Unit Description
Switch This field displays the unit identifier assigned to
the switch.
Unit Description