Administrator Guide

Switch Management Commands 2275
Command Mode
Stack Configuration mode
User Guidelines
This unit comes up as the master when the stack failover occurs. Use the no
form of this command to reset to default, in which case, a standby is
automatically selected from the existing stack units if there is no
preconfiguration.
Examples
console(config)#stack
console(config-stack)#standby 2
Command History
User Guidelines updated in the 6.4 release.
switch renumber
Use the switch renumber command in Global Configuration mode to change
the identifier for a switch in the stack.
Syntax
switch oldunit renumber newunit
• oldunit — The current switch identifier. (Range: Dependent on
Series/Model)
• newunit — The updated value of the switch identifier. (Range:
Dependent on Series/Model)
Command Mode
Global Configuration mode
User Guidelines
Upon execution, the switch is configured with the configuration information
for the new switch if any is available. The old switch configuration
information is retained; however, the original switch will be operationally