Administrator Guide

Using the CLI 263
AeroHive HiveManager NG EULA
This switch includes a feature that enables it to work with HiveManager (an
optional management suite), by sending the switch’s service tag number to
HiveManager to authenticate your entitlement to use HiveManager. If you wish
to disable this feature, you should run command “eula-consent hiveagent
reject” immediately upon powering up the switch for the first time, or at any
time thereafter.
Welcome to Dell Easy Setup Wizard
The setup wizard guides you through the initial switch configuration, and
gets you up and running as quickly as possible. You can skip the setup
wizard, and enter CLI mode to manually configure the switch. You must
respond to the next question to run the setup wizard within 60 seconds,
otherwise the system will continue with normal operation using the default
system configuration. Note: You can exit the setup wizard at any point
by entering [ctrl+z].
Would you like to run the setup wizard (you must answer this question within
60 seconds)? (y/n)
Regardless of if the administrator runs or does not run the Easy Setup wizard
and if the SupportAssist application is installed:
eula-consent support-assist accept
is entered into the running-config if the SupportAssist EULA Accept file
exists on the stack master and contains the ‘EULA: Accepted’ text.
Regardless of whether the administrator runs or does not run the Easy Setup
wizard and if the HiveAgent is installed:
eula-consent hiveagent accept
is entered into the running-config if the HiveAgent EULA Accept file exists
on the stack master and contains the ‘EULA: Accepted’ text.
The Easy Setup Wizard also prompts the user to configure a proxy server as
follows:
Step 5:
Would you like to configure the address of an HTTPS proxy server used by the
SupportAssist agent? [Y/N] y
Enter the IPv4 or IPv6 address of the proxy server:192.168.0.3
Enter the port number used by HTTPS [443]:
Enter the user name required to access the proxy server:
Enter the password required to access the proxy server:
This is the configuration information that has been collected:
User Account setup = admin