Administrator Guide

Layer 2 Switching Commands 454
collected on combo ports when the copper port is enabled. Use the no form of
the command to set the sampling interval or max-samples values to the
default.
Syntax
green-mode eee-lpi-history {sampling-interval 30 sec – 36000 sec| max-
samples 1 - 168}
• sampling-interval—The interval in seconds at which power consumption
data needs to be collected.
• max-samples—Maximum number of samples to keep.
Default Configuration
The sampling-interval default value is 3600 seconds and the max-samples
default value is 168.
Command Mode
Global Configuration
User Guidelines
EEE and energy-detect modes are only supported on N4000 series 10G
copper ports and on N1100-ON/N1500/N2000/N2100-ON/N3000/N3100-ON
1G copper ports.
Examples
Use the command below to set the EEE LPI History sampling interval to the
default.
console(config)# no green-mode eee-lpi-history sampling-interval
Use the command below to set the EEE LPI History max-samples to the
default.
console(config)#no green-mode eee-lpi-history max-samples