Administrator Guide

Layer 2 Switching Commands 696
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition using the specified
IP address and bit mask.
console(config-classmap)#match dstip 10.240.1.1 255.255.255.1
match dstip6
The match dstip6 command adds a match condition based on the
destination IPv6 address of a packet.
NOTE: This command is not available on the N1500 Series switches.
Syntax
match dstip6 destination-ipv6-prefix/prefix-length
• destination-ipv6-prefix — IPv6 prefix in IPv6 global address format.
• prefix-length — IPv6 prefix length value.
Default Configuration
There is no default configuration for this command.
Command Mode
Ipv6-Class-Map Configuration mode.
User Guidelines
There are no user guidelines for this command.