Users Guide

1056 Link Aggregation
Configuring Link Aggregation (CLI)
This section provides information about the commands used for configuring
link aggregation settings on the switch. For more information about the
commands, see the Dell EMC Networking N1100-ON, N1500, N2000,
N2100-ON, N2200-ON, and N3100-ON Series Switches CLI Reference
Guide at www.dell.com/support.
Configuring LAG Characteristics
Use the following commands to configure a few of the available LAG
characteristics. Many of the commands described in "Configuring Port
Characteristics (CLI)" on page 652 are also applicable to LAGs.
Command Purpose
configure Enter global configuration mode.
interface interface Enter interface configuration mode for the specified LAG.
The interface variable includes the interface type, which is
port-channel, and the LAG number, for example interface
port-channel 3.
A range of LAGs can be specified using the interface range
port-channel command. For example, interface range
port-channel 3-6 configures LAGs 3, 4, 5 and 6.
description description Configure a description for the LAG or range of LAGs
port-channel min-links
minimum
Set the minimum number of links that must be up in
order for the port-channel interface to be declared up.
exit Exit to Global Config mode.
CTRL + Z Exit to Privileged Exec mode.
show interfaces
description port-channel
port-channel number
View the configured description for the specified LAG.
show interfaces port-
channel [port-channel
number]
View LAG information for the specified LAG or for all
LAGs.