Users Guide

1326 RIP
Configuring RIP Interface Settings
Use the following commands to configure per-interface RIP settings.
Command Purpose
configure Enter global configuration mode.
interface vlan vlan-id Enter Interface Configuration mode for the specified
VLAN.
ip rip Enable RIP on the interface.
ip rip send version {rip1
rip1c | rip2 |none}
Configure the interface to allow RIP control packets of the
specified version(s) to be sent.
ip rip receive version
{rip1 | rip2 | both |
none}
Configure the interface to allow RIP control packets of the
specified version(s) to be received.
ip rip authentication
{none | {simple key} |
{encrypt key key-id}
set the RIP Version 2 Authentication Type and Key for the
interface.
• key — Authentication key for the specified interface.
(Range: 16 bytes or less)
• encrypt — Specifies the Ethernet unit/port of the
interface to view information.
• key-id — Authentication key identifier for
authentication type encrypt. (Range: 0-255)
exit Exit to Global Configuration Mode
exit Exit to Privileged Exec mode.
show ip rip interface vlan
vlan-id
View RIP configuration information for the specified
routing interface.
show ip rip interface
brief
View summary information about the RIP configuration
on all interfaces.