Users Guide

Images and File Management 539
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
Configuration Saved!
8 Reset the switch to boot the system with the new image.
console#reload
Are you sure you want to continue? (y/n)y
Reloading all switches...
Managing Configuration Scripts
This example shows how to create a configuration script that adds three
hostname-to-IP address mappings to the host table.
To configure the switch:
1 Open a text editor on an administrative computer and type the commands
as if you were entering them by using the CLI.
Figure 13-10. Create Config Script