Setup Guide

Installation

Unpacking Steps

NOTE:

Before unpacking the switch, inspect the container and immediately report

any evidence of damage.

Place the container on a clean, flat surface and cut all straps securing the

container.

Open the container or remove the container top.

Carefully remove the switch from the container and place it on a secure

and clean surface.

Remove all packing material.

Inspect the product and accessories for damage.

Rack Mounting the Switch

You may either place the switch on the rack shelf or mount the switch directly

into a 19" wide, EIA-310-E compliant rack (four-post, two-post, or threaded

methods). The Dell ReadyRails™ system is provided for 1U front-rack, and

two-post installations. The ReadyRails system includes two separately

packaged rail assemblies and two rails that are shipped attached to the sides

of the switch.

WARNING:

This is a condensed reference. Read the safety instructions in your

Safety, Environmental, and Regulatory information booklet before you begin.

NOTE:

The illustrations in this document are not intended to represent a specific

switch.