Administrator Guide

Layer 3 Routing Commands 1361
Command History
Introduced in version 6.2.0.1 firmware.
Modified in version 6.3.0.1 firmware.
Example
console(config)#show bgp ipv6 route-reflection
Cluster ID .................................... 65.1.1.1 (default)
Client-to-client Reflection ................... Enabled
Clients:
Non-client Internal Peers:
show ip bgp
To view routes in the BGP routing table, use the show ip bgp command in
Privileged EXEC mode. The output lists both the best and non-best paths to
each destination.
Syntax
show ip bgp [ network/pfx-length [longer-prefixes | shorter-prefixes
[
length ]]] | [filter-list as-path-list ] | [prefix-list list-name ]
• network/pfx-length —(Optional) Display a specific route identified by its
destination prefix
•
longer-prefixes —(Optional) Used with the network / pfx-len option to show
routes whose prefix length is equal to or longer than
pfx-len . This option
may not be given if the
shorter-prefixes option is given.
Client-to-Client Reflection Displayed as Enabled when this router reflects routes
received from its clients to its other clients. Disabled
otherwise.
Clients A list of this router’s internal peers which have been
configured as route reflector clients.
Non-client Internal Peers A list of this router’s internal peers that are not
configured as route reflector clients. Routes from non-
client peers are reflected to clients and vice-versa.
2CSNXXX_SWUM204.book Page 1361 Monday, January 25, 2016 1:25 PM