Administrator Guide

Layer 3 Routing Commands 1744
Syntax
exit-overflow-interval seconds
no exit-overflow-interval
• seconds — Number of seconds after entering overflow state that a router
will wait before attempting to leave the overflow state. (Range:
0–2147483647)
Default Configuration
0 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the exit overflow interval for OSPF at 10 seconds.
console(config-router)#exit-overflow-interval 10
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPF Configuration mode
to configure the external LSDB limit for OSPF. If the value is -1, then there is
no limit. When the number of non-default AS-external-LSAs in a router's
link-state database reaches the external LSDB limit, the router enters
overflow state. The router never holds more than the external LSDB limit
non-default AS-external-LSAs in it database. Use the no form of the
command to return the limit to the default value.
Syntax
external-lsdb-limit integer
no external-lsdb-limit
• integer — Maximum number of non-default AS-external-LSAs allowed in
the router's link-state database. (Range: –1 to 2147483647)
2CSNXXX_SWUM204.book Page 1744 Monday, January 25, 2016 1:25 PM