Administrator Guide

Dell Networking CLI 176
set ip default next-hop Sets a list of default next-hop IP addresses
to be used if
no explicit route for the packet’s
destination address appears in the routing table.
RM
set ip next-hop Specifies the adjacent next-hop router in the
path toward the destination to which the
packets should be forwarded.
RM
set ip precedence Sets the IP precedence bits in the IP packet
header.
RM
show ip brief Displays all the summary information of the IP. PE
show ip interface Displays all pertinent information about the IP
interface.
PE
show ip policy Displays the route maps used for policy based
routing on the router interfaces.
PE
show ip protocols Displays the parameters and current state of the
active routing protocols.
PE
show ip route Displays the routing table. PE
show ip route static Displays the configured routes, whether or
not they are reachable.
PE
show ip route preferences Displays detailed information about the route
preferences.
PE
show ip route summary Shows the number of all routes, including best
and non-best routes.
PE
show ip traffic Displays IP statistical information. UE or
PE
show ip vlan Displays the VLAN routing information for all
VLANs with routing enabled.
PE
show route-map Displays the route maps. PE
show routing heap summary
Displays a summary of the memory
allocation from the routing heap.
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 100.
Command Description Mode
a
2CSNXXX_SWUM204.book Page 176 Monday, January 25, 2016 1:25 PM