Administrator Guide

Layer 3 Routing Commands 1900
vrrp description
Use the vrrp description command in Interface Configuration mode to assign
a description to the Virtual Router Redundancy Protocol (VRRP) group. To
remove the description, use the no form of the command.
Syntax
vrrp group description text
no vrrp group description
• group —The virtual router identifier. (Range: 1-255)
•
text —Description for the virtual router group up to 80 characters.
Default Configuration
No description is present.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command accepts any printable characters for the name other than a
question mark. Descriptions containing spaces must be enclosed in quotes.
Example
The following example creates virtual router group 5 on VLAN 15 and
configures its description.
console(config)#interface vlan 15
console(config-if-vlan15)#vrrp 5
console(config-if-vlan15)#vrrp 5 description “Sales and Marketing”
vrrp ip
Use the vrrp ip command in Interface Configuration mode to enable VRRP
and set the virtual router IP address value for an interface. Use the no form of
the command remove the secondary IP address. It is not possible to remove
the primary IP address once assigned. Remove the VRRP group instead.
2CSNXXX_SWUM204.book Page 1900 Monday, January 25, 2016 1:25 PM