Administrator Guide

Switch Management Commands 2014
User Guidelines
Auto enables the switch to deliver power to the powered device. The power
inline management parameter should be set to class-based mode to enable
power negotiation via LLDP-MED..
Default Value
The default value is auto, that is, device discovery is enabled and the port is
capable of delivering power.
Examples
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)# power inline auto
power inline detection
Use the power inline detection command to configure the detection type
that tells which types of PD’s will be detected and powered by the switch. Use
the no form of this command to set the detection type to the default.
Syntax
power inline detection {dot3at+legacy | legacy-only}
no power inline detection
• dot3at+legacy —IEEE 802.3at 4-point detection followed by legacy
capacitive detection.
•
legacy-only —IEEE 802.3at 4-point detection only. Legacy capacitive
detection is disabled.
Default Configuration
The default value is dot3at+legacy.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
2CSNXXX_SWUM204.book Page 2014 Monday, January 25, 2016 1:25 PM