Administrator Guide

Switch Management Commands 2077
Use of the optional vrf parameter executes the command within the context
of the VRF specific routing table.
Syntax
debug ping packet [vrf vrf-name ]
no debug ping packet
• vrf-name —The name of the VRF associated with the routing table
context used by the command. If no vrf is specified, the global routing
table context is used.
Default Configuration
Display of ICMP echo traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
Only IPv4 addresses are supported with the
vrf parameter.
This command is only available on the N3000/N4000 switches.
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
The following example displays.
console#debug ping packet
debug rip
Use the debug rip command to enable tracing of RIP requests and responses.
Use the no form of this command to disable tracing of RIP requests and
responses.
2CSNXXX_SWUM204.book Page 2077 Monday, January 25, 2016 1:25 PM