Administrator Guide

Layer 2 Switching Commands 277
• [in | out | control-plane]— The packet direction. in applies the access-list
to ingress packets.
out applies the access-list to egress packets. control-
plane applies the access-list to ingress control plane packets. control-plane
is only valid in Global Configuration mode.
•
sequence — Order of access list relative to other access lists already
assigned to this interface and direction. (Range: 1-4294967295)
Default Configuration
No ACLs are configured by default.
Command Mode
Global Configuration mode or Interface Configuration (Ethernet, VLAN or
Port Channel) mode
User Guidelines
If the access-list specified in the command does not exist, an error is given.
The ACLs in the access-group are configured in hardware when the interface
becomes active. Resource contention issues will only become apparent at that
time. It is recommended that ACLs be configured on an active interface as a
check prior to deployment in the network.
An optional sequence number may be specified to indicate the order of this
access-list relative to the other access-lists already assigned to this interface
and direction. A lower number indicates higher precedence order. If a
sequence number already is in use for this interface and direction, the
specified access-list replaces the currently attached access list using that
sequence number. If the sequence number is not specified for this command,
a sequence number is selected that is one greater than the highest sequence
number currently in use for this interface and direction.
The optional control-plane keyword allows the application of an egress MAC
ACL on the CPU port.
This command specified in Interface Configuration mode only affects a
single interface.
2CSNXXX_SWUM204.book Page 277 Monday, January 25, 2016 1:25 PM