Administrator Guide

Layer 2 Switching Commands 580
Default Value
By default, the capabilities and network policy TLVs are included in LLDP
packets sent on interfaces enabled for MED
Example
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)#lldp med transmit-tlv capabilities
console(config-if-Gi1/0/1)#lldp med transmit-tlv network-policies
lldp notification
Use the lldp notification command in Interface Configuration mode to
enable remote data change notifications. To disable notifications, use the no
form of this command.
Syntax
lldp notification
no lldp notification
Default Configuration
By default, notifications are disabled on all supported interfaces.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to enable remote data change
notifications.
console(config-if-Gi1/0/3)#lldp notification
2CSNXXX_SWUM204.book Page 580 Monday, January 25, 2016 1:25 PM