Administrator Guide

Security Commands 909
–emergency (0)
–alert (1)
–critical (2)
– error (3)
–warning (4)
–notice (5)
–info (6)
–debug (7)
Default Configuration
The default severity level is info(6).
Command Mode
Global Configuration mode
User Guidelines
You can filter log messages that appear in the buffered log by severity level.
You can specify the severity level of log messages that are e-mailed. You can
use this command to specify the severity level at which SNMP traps are
logged, and thus control whether traps appear in the buffered log or are e-
mailed and, if they are e-mailed, whether traps are considered urgent or non-
urgent.
logging email message-type to-addr
Use the logging email message-type to-addr command in Global
Configuration mode to configure the To address field of the e-mail. The
message types supported are urgent, non-urgent, and both. For each
supported severity level, multiple e-mail addresses can be configured. For
example, for urgent type of messages, there could be multiple addresses
configured.
Syntax
logging email message-type {urgent | non-urgent | both} to-addr to-email-
addr
2CSNXXX_SWUM204.book Page 909 Monday, January 25, 2016 1:25 PM