Users Guide

Hardware Overview 153
Figure 3-19. Additional Dell EMC Networking N3000/N3000E-ON Series Ports
The Dell EMC Networking N3000/N3000E-ON Series front panel above also
contains a reset button (pinhole) and several status LEDs. See Figure 3-19.
The Dell EMC Networking N3000/N3000E-ON Series front panel displays,
from left to right, status LEDs for over-temperature alarm, internal power
supply 1, and switch status on the top row. The bottom row of status LEDs
displays, from left to right, the Stack Master, internal power supply 2, and fan
alarm status.
Switch Ports
The Dell EMC Networking N3024/N3024P/N3024ET-ON/N3024EP-ON
front panel provides 24 Gigabit Ethernet (10/100/1000BASE-T) RJ-45 ports
that support auto-negotiation for speed, flow control, and duplex. The Dell
EMC Networking N3024P models support two SFP+ 10G ports. Dell EMC-
qualified SFP+ transceivers are sold separately. The Dell EMC Networking
N3000/N3000E-ON Series switches operate in full-duplex mode only.
The Dell EMC Networking N3024F/N3024EF-ON front panel provides 24
Gigabit Ethernet 100BASE-FX/1000BASE-X SFP ports plus two 1000BASE-T
combo ports. The combo ports are set to prefer fiber. If using the 1000BASE-
T port, remove any transceivers from the SFP port. Dell EMC-qualified SFP
transceivers are sold separately. 1000BASE-X and 1000BASE-T operation
requires the use of auto-negotiation.
Combo Ports
Reset Button
USB Port
Console Port
Out-of-Band Management Port
SFP+ Ports