Concept Guide
interface GigabitEthernet 2/6
no ip address
shutdown
!
interface GigabitEthernet 2/7
no ip address
shutdown
!
interface GigabitEthernet 2/8
no ip address
shutdown
!
interface GigabitEthernet 2/9
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the congurations applied on an interface to its factory default state. To reset the conguration, perform the following steps:
1 View the congurations applied on an interface.
INTERFACE mode
show config
DellEMC(conf-if-gi-1/5)#show config
!
interface GigabitEthernet 1/5
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
DellEMC(conf)#default interface gigabitethernet 1/5
3 Verify the conguration.
INTERFACE mode
show config
DellEMC(conf-if-gi-1/5)#show config
!
interface GigabitEthernet 1/5
no ip address
shutdown
All the applied congurations are removed and the interface is set to the factory default state.
Enabling a Physical Interface
After determining the type of physical interfaces available, to enable and congure the interfaces, enter INTERFACE mode by using the
interface interface command.
1 Enter the keyword interface then the type of interface and slot/port information.
CONFIGURATION mode
Interfaces
345