Service Manual
Parameters
seconds Enter the number of seconds as the interval between retransmission. The range is
from 1 to 3600. The default is 1 second.
This value must be greater than the transmission and propagation delays for the
interface.
Defaults 1 second
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
log-adjacency-changes
To send a Syslog message about changes in the OSPF adjacency state, set Dell Networking OS.
S3048–ON
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes command.
Defaults Disabled.
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
1012
Open Shortest Path First (OSPFv2 and OSPFv3)