Service Manual

show cong
Display the non-default values in the current OSPF conguration.
S3048–ON
Syntax
show config
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface 0 GigabitEthernet 1/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process congured on the switch.
S3048–ON
Syntax
show ip ospf [process-id]
Parameters
process-id Enter the OSPF Process ID to show a specic process. If no Process ID is entered,
command applies only to the rst OSPF process.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
1022
Open Shortest Path First (OSPFv2 and OSPFv3)