Service Manual
Defaults Default cost based on the bandwidth.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.1.(0.0) Introduced on the S4810 and Z9000.
7.8.1.0 Added support for C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage Information
In general, the path cost is calculated as:
10^8 / bandwidth
Using this formula, the default path cost is calculated as:
• GigabitEthernet—Default cost is 1
• TenGigabitEthernet—Default cost is 1
• FortygigEthernet — Default cost is 1
• Ethernet—Default cost is 10
ipv6 ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers
declare the router down.
Syntax
ipv6 ospf dead-interval seconds
To return to the default time interval, use the no ipv6 ospf dead-interval command.
Parameters
seconds
Enter the time interval in seconds. The range is from 1 to 65535 seconds.
Defaults 40 seconds (Ethernet).
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
Open Shortest Path First (OSPFv2 and OSPFv3)
1067