Service Manual

bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the
following TCP ags:
• ack = acknowledgement
• fin = nish (no more data from the user)
•
psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent eld
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
•
gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two ports for the
portcommand parameter.)
Defaults none
Command Modes REDIRECT-LIST
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series Tera Scale.
7.7.1.0 Introduced on the E-Series ExaScale.
redirect
Congure a rule for the redirect list.
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track <obj-id>] {ip-
protocol-number | protocol-type [bit]} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [operator]
To remove this lter, use one of the following:
• Use the no seq sequence-number command if you know the lter’s sequence number.
•
You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}
[track <obj-id>] {ip-protocol-number [bit] | protocol-type} {source mask
1088
Policy-based Routing (PBR)