Service Manual

Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series ExaScale.
Usage Information The following describes the show ip pim snooping neighbor commands shown in the following
example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through PIM-SM snooping.
Interface Displays the VLAN ID number and slot/port on which the PIM-SM-enabled
neighbor was discovered.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time
until the neighbor is removed from the multicast routing table (that is, until the
neighbor hold time expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim dr-priority
command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [Gi 1/13 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [Gi 1/11 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [Gi 2/20 ] 00:00:51/00:01:24 v2 0
show ip pim snooping tib
Display information from the tree information base (TIB) PIM-SM snooping discovered about multicast group members and states.
Syntax
show ip pim snooping tib [vlan vlan-id] [group-address [source-address]]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display TIB information PIM-SM snooping
discovered on a specied VLAN. The valid VLAN IDs range is from 1 to 4094.
group-address (OPTIONAL) Enter the group address in dotted decimal format (A.B.C.D) to display
TIB information PIM-SM snooping discovered for a specied multicast group.
PIM-Sparse Mode (PIM-SM)
1115