Service Manual

monitor session
Create a session for monitoring trac with port monitoring.
Syntax
monitor session session-ID [type { rpm | erpm [set ip dscp dscp_value | set
ip ttl ttl_value]}] [drop]
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session all command.
Parameters
session-ID Enter a session identication number. The range is from 0 to 65535.
type Species one of the following type:
• rpm
• erpm
rpm Creates a remote port monitoring (rpm) session.
erpm Creates an encapsulated remote port monitoring (erpm) session.
set ip dscp Congures the Dierentiated Services Code Point (DSCP) value of the packets in
the Encapsulated Remote Switched Port Analyzer (ERSPAN) trac. To revert to
the default value, use the no form of this command.
dscp_value DSCP value of the packets in the ERSPAN trac. The range is from 0 to 63. The
default value is 0.
set ip ttl Congures the IP time-to-live (TTL) value of the Encapsulated Remote Switched
Port Analyzer (ERSPAN) trac. To revert to the default conguration, use the no
form of this command.
ttl_value IP TTL value of the ERSPAN trac. The range is from 1 to 255. The default value is
255.
drop Monitors only the dropped packets in the Ingress.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the drop parameter. Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON. Introduced the set ip dscp and set ip ttl
parameters.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
9.0.2.0 Introduced on the S6000.
9.0.2.0 Introduced on the MXL.
1124
Port Monitoring