Service Manual

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced.
Example
Dell(conf-pvst)#do show spanning-tree pvst vlan 5 brief
VLAN 5
Executing IEEE compatible Spanning Tree Protocol
Root ID Priority 32773, Address 0001.e832.73f7
Root Bridge hello time 2, max age 20, forward delay 15
Bridge ID Priority 32773 (priority 32768 sys-id-ext 5), Address
0001.e832.73f7
We are the root of Vlan 5
Configured hello time 2, max age 20, forward delay 15
Interface Designated
Name PortID Prio Cost Sts Cost Bridge ID PortID
-------------------------------------------------------------
Gi 1/10 128.140 128 200000 FWD 0 32773 0001.e832.73f7 128.140
Gi 1/12 128.142 128 200000 DIS 0 32773 0001.e832.73f7 128.142
Interface
Name Role PortID Prio Cost Sts Cost Link-type Edge
--------------------------------------------------------
Gi 0/10 Desg 128.140 128 200000 FWD 0 P2P No
Gi 0/12 Dis 128.142 128 200000 DIS 0 P2P No
Related Commands
protocol spanning-tree pvst – enter SPANNING TREE mode on the switch.
protocol spanning-tree pvst
To enable PVST+ on a device, enter the PVST+ mode.
S3048
Syntax
protocol spanning-tree pvst
To disable PVST+, use the disable command.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Per-VLAN Spanning Tree Plus (PVST+)
1139