Service Manual

router rip
network 172.31.0.0
passive-interface GigabitEthernet 1/1
Dell(conf-router_rip)#
show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
S3048–ON
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format to view RIP
information on that network only. If you enter an IP address, also enter a mask for
that IP address.
mask (OPTIONAL) Specify a mask, in /network format, for the IP address.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip rip database command shown in the following example.
Field Description
Total number of
routes in RIP
database
Displays the number of RIP routes stored in the RIP database.
100.10.10.0/24
directly connected
Lists the routes directly connected.
150.100.0.0
redistributed
Lists the routes learned through redistribution.
1220
Routing Information Protocol (RIP)