Service Manual

protocol spanning-tree rstp
To congure RSTP, enter RSTP mode.
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not congured
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the no
disable command from RSTP mode.
Example
Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
Related Commands disable — disables RSTP globally on the system.
show cong
View the current conguration for the mode. Only non-default values are displayed.
Syntax
show config
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1246
Rapid Spanning Tree Protocol (RSTP)