Service Manual

ip tacacs source-interface
Specify an interface’s IP address as the source IP address for TACACS+ connections.
Syntax
ip tacacs source-interface interface
To delete a source interface, use the no ip tacacs source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
tacacs-server group
Creates a group of TACACS servers.
Syntax
tacacs-server group group-name
To delete a group of TACACS servers, use the no tacacs-server group group-name command.
Security
1291