Service Manual

Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage Information
If you congure a VRF for an SSH session, then you need not explicitly mention the same VRF for the SSH
client sessions intended for that VRF. The vrf attribute in the ip ssh vrf command is applicable for
both the SSH client as well as the COPY (SCP) commands.
Example
Dell(conf)#ip ssh vrf vrf1
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh vrf vrf1
show crypto
Display the public part of the SSH host-keys.
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more information, contact your Dell Networking representative.
show crypto key mypubkey {rsa | rsa1}
Parameters
Key Enter the keyword key to display the host public key.
mypubkey Enter the keyword mypubkey to display the host public key.
rsa Enter the keyword rsa to display the host SSHv2 RSA public key.
rsa1 Enter the keyword rsa1 to display the host SSHv1 RSA public key.
NOTE: If you enable FIPS mode, this parameter is not available.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
1322
Security