Service Manual
-p port-number (OPTIONAL) Enter the keyword -p then the port number. The range is from 1 to
65535. The default is 22.
-v {1 | 2} (OPTIONAL) Enter the keyword -v then the SSH version 1 or 2. The default is the
version from the protocol negotiation.
Defaults As shown in the Parameters section.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Added support for the -c and -m parameters on the S4810.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Added IPv6 support. Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information Dell Networking OS supports both inbound and outbound SSH sessions using IPv4 or IPv6 addressing.
Inbound SSH supports accessing the system through the management interface as well as through a
physical Layer 3 interface.
Example
Dell#ssh 10.16.151.48 -l anvltest
Trying 10.16.151.48...
01:18:16: %STKUNIT0-M:CP %SEC-5-SSH_USAGE: Initiated SSH Client v2 (FIPS
Disabled) to anvltest@10.16.151.48 by default from console
anvltest@10.16.151.48's password:
Last login: Thu Jan 5 00:17:47 2012 from login-maa-101
[anvltest@dt-maa-linux-1 ~]# exit
logout
Dell#
Secure DHCP Commands
DHCP as dened by RFC 2131 provides no authentication or security mechanisms. Secure DHCP is a suite of features that protects
networks that use dynamic address allocation from spoong and attacks.
Security
1327