Service Manual

Parameters
rate Enter the rate in frames per second. The range is from 75 to 3000. The default is
75.
Defaults 75 frames per second.
Command Modes CONF-IF-VLAN-STACK
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series, E-Series TeraScale, and E-Series ExaScale. Maximum
rate limit on E-Series reduced from 4000 to 3000.
7.4.1.0 Introduced
Example
Dell(conf-if-vl-2)#vlan-stack compatible
Dell(conf-if-vl-2-stack)#protocol-tunnle rate-limit 100 <<<<<<<< VLAN
stack mode
Dell(conf-if-vl-2-stack)#show config
!
interface Vlan 2
no ip address
mtu 1000
vlan-stack compatible
protocol-tunnel rate-limit 100
shutdown
Related Commands
show protocol-tunnel — displays tunneling information for all VLANs.
show running-cong — displays the current conguration.
show protocol-tunnel
Display protocol tunnel information for all or a specied VLAN-Stack VLAN.
Syntax
show protocol-tunnel [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display information for
the one VLAN. The range is from 1 to 4094.
Defaults none
1344
Service Provider Bridging