Service Manual

• v1v2cwriteu/ v1v2cwriteg — maps to a community with rw (read-write) permissions.
The community-name parameter indexes this command.
If you do not congure the snmp-server community command, you cannot query SNMP data. Only
Standard IPv4 ACL and IPv6 ACL is supported in the optional access-list-name.
The command options ipv6, security-name, and access-list-name are recursive. In other words,
each option can, in turn, accept any of the three options as a sub-option, and each of those sub-options can
accept any of the three sub-options as a sub-option, and so forth. The second Example shows the creation
of a standard IPv4 ACL called snmp-ro-acl and then assigning it to the SNMP community guest.
NOTE: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP; TCP and ICMP rules are not
valid for SNMP. In IPv6 ACLs, port rules are not valid for SNMP.
Example
Dell#config
Dell(conf)# snmp-server community public ro
Dell(conf)# snmp-server community guest ro security-name guestuser
Dell(conf)#
Example
Dell(conf)# ip access-list standard snmp-ro-acl
Dell(config-std-nacl)#seq 5 permit host 10.10.10.224
Dell(config-std-nacl)#seq 10 deny any count
!
Dell(conf)#snmp-server community guest ro snmp-ro-acl
Dell(conf)#
Related Commands
ip access-list standard — names (or selects) a standard access list to lter based on IP address.
ipv6 access-list — congures an access list based on IPv6 addresses or protocols.
show running-cong — displays the current SNMP conguration and defaults.
snmp-server contact
Congure contact information for troubleshooting this SNMP node.
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact command.
Parameters
text Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
Simple Network Management Protocol (SNMP) and Syslog
1363