Service Manual

access-list-name
ipv6 access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Added support for the access parameter.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information The following Example species the group named harig as a version 3 user requiring both authentication and
encryption and read access limited to the read named rview.
NOTE: The number of congurable groups is limited to 16 groups.
Example
Dell#conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related Commands
show snmp group — displays the group name, security model, view status, and storage type of each group.
show running-cong — displays the SNMP running conguration.
snmp-server host
Congure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address traps | informs [version 1 | 2c
| 3] [auth | no auth | priv] [community-string] [udp-port port-number]
[notification-type]
To remove the SNMP host, use the no snmp-server host ip-address traps | informs
[version 1 | 2c | 3] [auth | noauth | priv] [community-string] [udp-port
number] [notification-type] command.
1368
Simple Network Management Protocol (SNMP) and Syslog