Service Manual

Version Description
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server packetsize
Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a reply, use the snmp-
server packetsize global configuration command.
Syntax
snmp-server packetsize byte-count
Parameters
byte-count Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000 bytes,
16000 bytes, 32000 bytes, and 64000 bytes.
Defaults 8
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server trap-source
Congure a specic interface as the source for SNMP trac.
Syntax
snmp-server trap-source interface
To disable sending traps out a specic interface, use the no snmp trap-source command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
1372
Simple Network Management Protocol (SNMP) and Syslog