Service Manual

323 frrp 5206016 241664 369238 0 369238 369238
322 xstp 7430144 2928640 38328 0 38328 38328
321 pim 5267456 823296 62168 0 62168 62168
314 igmp 4960256 380928 18588 16564 18588 2024
313 mrtm 6742016 1130496 72758 0 72758 72758
308 l2mgr 5607424 552960 735214 380972 619266 354242
301 l2pm 5001216 167936 1429522 1176044 286606 253478
298 arpm 4628480 217088 71092 33128 71092 37964
294 ospf 5468160 503808 724204 662560 78208 61644
288 dsm 6778880 1159168 39490 16564 39490 22926
287 rtm 5713920 602112 442280 198768 376024 243512
284 rip 4562944 258048 528 0 528 528
281 lacp 4673536 266240 221060 0 221060 221060
277 ipm1 4837376 380928 83788 0 83788 83788
273 acl 5005312 512000 239564 149076 123616 90488
272 topoDPC 117927936 0 0 0 0 0
271 bcmNHOP 117927936 0 0 0 0 0
270 bcmDISC 117927936 0 0 0 0 0
269 bcmATP-RX 117927936 0 0 0 0 0
268 bcmATP-TX 117927936 0 0 0 0 0
267 bcmSTACK 117927936 0 0 0 0 0
266 bcmRX 117927936 0 0 0 0 0
265 bcmLINK.0 117927936 0 0 0 0 0
!----------- output truncated --------------!
show software ifm
Display interface management (IFM) data.
Syntax
show software ifm {clients [summary] | ifagt number | ifcb interface |
stack-unit unit-ID | trace-flags}
Parameters
clients Enter the keyword clients to display IFM client information.
summary (OPTIONAL) Enter the keyword summary to display brief information about IFM
clients.
ifagt number Enter the keyword ifagt then the number of an interface agent to display
software pipe and IPC statistics.
ifcb interface Enter the keyword ifcb then one of the following interface IDs then the slot/port
information to display interface control block information for that interface:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
•
For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
stack-unit unit-ID Enter the keyword stack-unit then the stack member number to display IFM
information for that unit.
NOTE: This option is only available on the S-Series.
trace-ags Enter the keyword trace-flags to display IFM information for internal trace
ags.
138
Control and Monitoring