Service Manual

Related Commands
• reload – reboots Dell Networking OS.
stack-unit provision
Precongure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the management
unit.
Syntax
stack-unit [stack-number] provision {S4810|S4820T|S6000|Z9000}
Parameters
stack-unit Enter a stack member identier of the switch that you want to add to the stack.
S4810|S4820T|
S6000|Z9000
Enter the model identier of the switch to be added as a stack member. This
identier is also referred to as the provision type.
Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member
identier.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related Commands
• reload – reboots Dell Networking OS.
• show system (S-Series and Z-Series) – displays the status of all stack members or a specic member.
stack-unit stack-group
Congure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is assigned to the
correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group conguration, use the no stack-unit unit-id stack-group
stack-id command.
Parameters
unit-id Enter the stack unit ID.
Stacking
1411