Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1411

storm-control multicast (Interface)

Congure the percentage of multicast trac allowed on an C-Series or S-Series interface (ingress only) network only.

Syntax

storm-control multicast packets_per_second in

To disable multicast storm control on the interface, use the no storm-control multicast

packets_per_second in command.

Parameters

packets_per_secon

d in

Enter the packets per second of broadcast trac allowed into the network. The

range is from 0 to 33554368.

Defaults none

Command Modes INTERFACE (conf-if-interface-slot/port)

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the C-series and S-Series.

storm-control unknown-unicast (Conguration)

Congure the percentage of unknown-unicast trac allowed in or out of the network.

Syntax

storm-control unknown-unicast [packets_per_second in]

To disable storm control for unknown-unicast trac, use the no storm-control unknown-unicast

[packets_per_second in] command.