Service Manual

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
Usage Information Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
storm-control unknown-unicast (Interface)
Congure percentage of unknown-unicast trac allowed on an interface (ingress only).
Syntax
storm-control unknown-unicast [percentage decimal_value in] | [wred-profile
name]] [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-control unknown-
unicast [percentage decimal_value in] | [wred-profile name]]
[packets_per_second in] command.
Parameters
percentage
decimal_value [in |
out]
E-Series Only: Enter the percentage of broadcast trac allowed in or out of the
network. Optionally, you can designate a decimal value percentage, for example,
55.5%.
The percentage is from 0 to 100:
• 0% blocks all related trac.
• 100% allows all trac into the interface.
The decimal range is from 0.1 to 0.9.
wred-prole name E-Series Only: (Optionally) Enter the keywords wred-profile followed by the
prole name to designate a wred-prole.
packets_per_secon
d in
C-Series and S-Series Only: Enter the packets per second of broadcast trac
allowed into the network. The range is from 0 to 33554431.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Storm Control
1421