Service Manual

ntp multicast client
To receive NTP information from the network via multicast, congure the switch.
Syntax
ntp multicast client [multicast-address]
To disable multicast reception, use the no ntp multicast client [multicast-address]
command.
Parameters
multicast-address (OPTIONAL) Enter a multicast address. Enter either an IPv4 address in dotted
decimal format or an IPv6 address in X:X:X:X::X format. If you do not enter a
multicast address, the address:
• 224.0.1.1 is congured if the interface address is IPv4
• 05::101 is congured if the interface address is IPv6
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added support for IPv6 multicast addresses.
8.3.7.0 Introduced on the S4810.
6.1.1.0 Introduced on the E-Series.
ntp master <stratum>
Congure the switch as NTP Server.
Syntax
ntp master <stratum>
Parameters
ntp
master<stratum>
Enter the stratum number to identify the NTP Server's hierarchy.
Defaults Not congured.
Command Modes CONFIGURATION
1444
System Time and Date