Service Manual

show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP group.
Syntax
show vrrp [vrrp-id] [vrf vrf-name] [interface] [brief][ipv6]
Parameters
vrrp-id (OPTIONAL) Enter the Virtual Router Identier for the VRRP group to view only
that group. The range is from 1 to 255.
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view active
VRRP groups corresponding to that VRF.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For Port Channel interface types, enter the keywords port-channel then
the number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN
ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the
VRRP groups.
ipv6 (OPTIONAL) Enter the keyword ipv6 to view only VRRP IPv6 groups.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information The following describes the show vrrp brief command shown in the following example.
1526
Virtual Router Redundancy Protocol (VRRP)