Service Manual

Version Description
9.0.0.0 Introduced on the Z9000
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information You can congure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each. Each time this
command is issued, it replaces the previously congured address of the same family, IPv4 or IPv6. The no
virtual-ip command takes an address/prex-length argument, so that the desired address only is
removed. If you enter the
no virtual-ip command without any specied address, then both IPv4 and
IPv6 virtual addresses are removed.
Related Commands ip address — assigns a primary and secondary IP address to the interface.
write
Copy the current conguration to either the startup-conguration le or the terminal.
Syntax
write {memory compressed| terminal}
Parameters
memory Enter the keyword memory to copy the current running conguration to the
startup conguration le. This command is similar to the copy running-
config startup-config
command.
compressed Enter the keyword compressed to write the operating conguration to the
startup-cong le in the compressed mode.
terminal Enter the keyword terminal to copy the current running conguration to the
terminal. This command is similar to the show running-config command.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Control and Monitoring
153