Service Manual

Save the conguration and reload the system for the delay timers to take eect.
Related Command vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.
vrrp-group
Assign a VRRP ID to an interface. You can congure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information The VRRP group only becomes active and sends VRRP packets when a virtual IP address is congured.
When you delete the virtual address, the VRRP group stops sending VRRP packets.
Related Command virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
version
Set VRRP protocol version for IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the 2 parameter to specify VRRP version 2 as dened by RFC 3768, Virtual
Router Redundancy Protocol.
3 Enter the 2 parameter to specify VRRP version 3 as dened in RFC 5798, Virtual
Router Redundancy.
1532
Virtual Router Redundancy Protocol (VRRP)