Service Manual
ip control-plane egress-lter
Enable egress Layer 3 ACL lookup for IPv4 CPU trac.
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
show ip accounting access-list
Display the IP access-lists created on the switch and the sequence of lters.
Syntax
show ip accounting {access-list access-list-name | cam_count} interface
interface [vrf vrf-name]
Parameters
access-list-name Enter the name of the ACL to be displayed.
cam_count List the count of the CAM rules for this ACL.
interface interface Enter the keyword interface then the one of the following keywords and slot/
port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
in | out Identify whether ACL is applied on the ingress or egress side.
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF to view the IP
accounting information on either a default or a non-default VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
196
Access Control Lists (ACL)